Found 1 file(s) to be processed in ROMFS.
Processing xrpc_xload_yamon_ES4_prod.bin (start: 0x8c040090, size: 0x0002fe84)
Checking zboot file signature .. Not found.
Trying xrpc_xload format .. OK
Checking zboot file signature at 0x13000000 .. OK
Decompressing to 0x91200000 .. OK (453328/0x6ead0).
Load time total 173/255 msec.
Execute final at 0x91200000 ..
**********************************
* YAMON ROM Monitor
* Revision 02.06-SIGMADESIGNS-01-2.8.0.1
**********************************
Memory: code: 0x11000000-0x11040000, 0x11200000-0x11204000
reserved data: 0x11240000-0x12440000, PCI memory: 0x12440000-0x12840000
Environment variable 'start' exists. After 1 seconds
it will be interpreted as a YAMON command and executed.
Press Ctrl-C (or do BREAK) to bypass this.
YAMON> setenv bootserver 192.168.1.3
Updating XENV block at 0x48000000.
.
XENV verification OK.
YAMON> setenv gateway 192.168.1.1
Updating XENV block at 0x48000000.
.
XENV verification OK.
YAMON> setenv ipaddr 192.168.1.21
Updating XENV block at 0x48000000.
.
XENV verification OK.
YAMON> setenv subnetmask 255.255.255.0
Updating XENV block at 0x48000000.
.
XENV verification OK.
YAMON> net init
Ethernet driver for EM86XX (v1.0)
(MAC 00:02:14:13:f0:09, tx_desc/rx_desc = 16/32)
em86xx_eth
pen(em86xx_eth) - Full-duplex mode
em86xx_eth
pen(em86xx_eth) - 100 Mbit/s
em86xx_eth ethernet start
ipaddr: 192.168.1.21
subnetmask: 255.255.255.0
gateway: 192.168.1.1
YAMON> net up
em86xx_eth ethernet start
YAMON> load -b tftp://192.168.1.3/vmlinux.bin 0x90020000
About to load tftp://192.168.1.3/vmlinux.bin
Press Ctrl-C to break
................................................................
................................................................
................................................................
................................................................
.......................................
Start = 0x90020000, range = (0x90020000,0x9095880f), format = BINARY
Length = 0x938810 (9668624)
Checksum = 0x2254194d
YAMON> go
em86xx_eth ethernet stop
Linux version 2.6.22.19-19-the_ripper (root@debian) (gcc version 4.3.2 (Debian 4.3.2-1.1) ) #185 PREEMPT Mon May 31 16:44:40 CEST 2010
Configured for SMP863x (revision ES6+/RevA+), detected SMP8634 (revision ES9/RevC).
Detected CPU/System/DSP Frequencies: 300.37/200.25/300.37MHz
SMP86xx Enabled Devices under Linux/XENV 0x48000000 = 0x00021ace
BM/IDE PCIHost Ethernet I2CM I2CS USB PCIDev2 PCIDev3 SCARD
Valid MEMCFG found at 0x10000fc0.
CPU revision is: 00019069
Determined physical RAM map:
memory: 06be0000 @ 10020000 (usable)
User-defined physical RAM map:
memory: 06ae0000 @ 10020000 (usable)
Wasting 2098176 bytes for tracking 65568 unused pages
Initrd not found or empty - disabling initrd
On node 0 totalpages: 92928
DMA zone: 726 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 92202 pages, LIFO batch:31
Normal zone: 0 pages used for memmap
Built 1 zonelists. Total pages: 92202
Kernel command line: mem=107m console=ttyS0,115200
Primary instruction cache 16kB, 2-way, physically tagged, linesize 16 bytes.
Primary data cache 16kB, 2-way, virtually tagged, cache aliases, linesize 16 bytes
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 2048 (order: 11, 8192 bytes)
Using 150.188 MHz high precision timer.
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 96384k/109440k available (4018k kernel code, 12948k reserved, 1013k data, 4408k init, 0k highmem)
Calibrating delay loop... 295.93 BogoMIPS (lpj=147968)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
tangox: creating TLB mapping for 0x20000000 at 0xc0000000, size 0x08000000.
PCI: Initializing SMP86xx PCI host controller
PCI: Remapped PCI I/O space 0x58000000 to 0xc8020000, size 64 kB
PCI: Remapped PCI config space 0x50000000 to 0xc8004000, size 10 kB
PCI: device 1 disabled
PCI: device 4 disabled
PCI: Configured SMP86xx as PCI slave with 128MB PCI memory
PCI: Region size is 16384KB
PCI: Map DMA memory 0x10020000-0x16b00000 for PCI at 0x11000000
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Time: TANGOX clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 4096 (order: 2, 16384 bytes)
TCP established hash table entries: 16384 (order: 5, 131072 bytes)
TCP bind hash table entries: 16384 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 16384 bind 16384)
TCP reno registered
Created /proc/cpucache_info entry.
Tango2 frequency scaling module installed.
NTFS driver 2.1.28 [Flags: R/W DEBUG].
JFFS2 version 2.2. © 2001-2006 Red Hat, Inc.
fuse init (API version 7.8)
SGI XFS with large block numbers, no debug enabled
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
Generic RTC Driver v1.07
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 9) is a 16550A
serial8250: ttyS1 at MMIO 0x0 (irq = 10) is a 16550A
loop: module loaded
nbd: registered device at major 43
tango2_enet: ethernet driver for SMP863x internal mac
tango2_enet: detected phy at address 0x01
tango2_enet: mac address 00:02:14:13:f0:09
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ide0: SMP86xx Bus Mastering IDE controller
Probing IDE interface ide0...
hda: DM255610V010, ATA DISK drive
hda: no 80 conductors cable, falling back to lower udma mode
hda: selected mode 0x42
hda: set to Ultra DMA mode 2
ide0: DMA enabled for ATA DISK hda
ide0 at 0x223c0-0x223c7,0x22398 on irq 26
hda: max request size: 128KiB
hda: 501760 sectors (256 MB) w/1KiB Cache, CHS=980/16/32, UDMA(33)
hda:
QLogic Fibre Channel HBA Driver
physmap flash device CS2: 0x800000 at 0x48000000
CS2: Physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
Using physmap partition definition
Adding partition #1-#5
Creating 5 MTD partitions on "CS2: Physically mapped flash":
0x00000000-0x00020000 : "CS2-Part1"
0x00020000-0x00040000 : "CS2-Part2"
0x00040000-0x00080000 : "CS2-Part3"
0x00080000-0x00700000 : "CS2-Part4"
0x00700000-0x00800000 : "CS2-Part5"
PCI: Enabling device 0000:00:02.2 (0000 -> 0002)
ehci_hcd 0000:00:02.2: EHCI Host Controller
ehci_hcd 0000:00:02.2: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:02.2: irq 22, io mem 0x62000000
ehci_hcd 0000:00:02.2: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 4 ports detected
driver tangox-ehci-hcd, 10 Dec 2004
TangoX USB initializing...
tangox-ehci-hcd tangox-ehci-hcd: TangoX USB 2.0
tangox-ehci-hcd tangox-ehci-hcd: new USB bus registered, assigned bus number 2
tangox-ehci-hcd tangox-ehci-hcd: irq 48, io mem 0xa0021400
tangox-ehci-hcd tangox-ehci-hcd: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Freeing unused kernel memory: 4408k freed
Algorithmics/MIPS FPU Emulator v1.5
Initializing random number generator... done.
Starting network...
ip: RTNETLINK answers: File exists
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
udhcpc (v1.16.1) started
Sending discover...
Sending discover...
Sending select for 192.168.1.2...
Lease of 192.168.1.2 obtained, lease time 259200
deleting routers
route: SIOCDELRT: No such process
adding dns 80.58.61.250
adding dns 80.58.61.254
===> Starting services...
[TD210] INITIALIZED END
[TD210] SLEEP MODE OFF
RF Detected
SCART Detected
PCB Version : 0xb
Micom Version : 0xb
===> [1] telnetd starting...
===> [2] mounting DOM ...
mount: mounting /dev/hda1 on /MMP failed: No such device or address
mount: mounting /dev/hda2 on /PLUGINS failed: No such device or address
mount: mounting /dev/hda3 on /DISK2 failed: No such device or address
mount: mounting /dev/hda4 on /Download failed: No such device or address
insmod: can't read '/MMP/modules/2.6.22/llad.ko': No such file or directory
insmod: can't read '/MMP/modules/2.6.22/em8xxx.ko': No such file or directory
===> Starting vsftpd...
AZBOX login: