Home

Instalar imagen por USB / Flash image by USB

Estado
Cerrado para nuevas respuestas.

darkmantk

OpenSpa Team
Miembro del equipo
26 Ago 2009
8.533
2.648
0
INSTALAR IMAGEN POR USB
Antes de empezar, debemos preparar el pendrive (formateado en FAT32) con los archivos necesarios.

1) Bajarse la imagen para vuestro modelo en https://openspa.webhop.info/
2) Descomprimir archivo y guardar la carpeta entera con el nombre de vuestro deco (formuler4turbo) en la raíz del pendrive.
3) Sacar pendrive de vuestro PC

Vamos a cargar la imagen :

1) Quitar la corriente al receptor (desenchufar o apagar desde el firmware)
2) Insertar vuestro pendrive con la imagen OpenSPA previamente descargada y descomprimida.
3) Conectar de nuevo el receptor
4) Cuando el receptor encienda, verás USB en el display. Tan pronto lo veas, presiona el botón POWER del lateral del receptor para empezar el flasheo. Empezarás a ver F300, F500 y finalmente F700.
5) Si todo ha ido bien, el receptor se reiniciará solo al acabar la instalación.
6) Quitar el pendrive y ya tendrás la nueva imagen en tu receptor.

El proceso de instalación durará entre 2 y 4 min. Mientras el receptor se esté flasheando, NO desconectarlo de la corriente, ya que puede causar daños irreparables.

Si el receptor arranca con la imagen de la flash, y pasa del contenido del pendrive, comprueba que hayas copiado en la raíz del pendrive la carpeta con el nombre de tu receptor o cambia de pendrive.
-------------------------------------------------------

FLASH IMAGE BY USB

Before starting, we must prepare pendrive (FAT32 formatted) with right files :

1) Download image for your box at https://openspa.webhop.info/
2) Unpack file and save folder with box name (formuler4turbo) in root of pendrive.
3) Remove pendrive from your PC

Let's go to install image :

1) Power off the receiver (unplug or push deep standby in firmware)
2) Insert the USB stick with OpenSPA image previously downloaded and unpacked.
3) Power the receiver on.
4) When the receiver powers up you will see USB on display. As soon as you see press the POWER on the side of the receiver to start the flashing process. You see F300, F500 and F700.
5) If successful the receiver will reboot itself after the flashing process has completed.
6) Remove USB stick and your new image will be yet installed.

The flashing process should take approximately two to four minutes to complete. While the receiver is being flashed, DO NOT power the receiver down because you can cause permanent damage.

If the receiver bypasses the files on the USB stick and boots into the existing image instead new one, you need to check that the file structure is correct on the USB stick or change your USB stick.
 
Estado
Cerrado para nuevas respuestas.